LEDs - Gallium Indium Nitride UV, violet, purple, blue, aqua, turquoise, green, white. Also Gallium Arsenide and others. New LED MUSEUM! GaN, InGaN, SiC, GaAs, GaP, GaAlP, ZnSe, flashlight, flashlights.

ELECTRONIC DIGITAL CALIPER

Electronic Digital Caliper, retail $9.99
Manufactured by (Unknown)
Last updated 07-01-20

This product does not emit light of its own (much like this spectrometer and this meter), so the standard review format will not be used and the product will be assigned a rating at once.

This is a low-priced digital caliper; it measures in mm and inches, and has a measurement resolution of just 100µ (µ=microns) -- or 0.10mm if you prefer.

It can be used to measure the physical size of an object up to 150mm in size; it also comes equipped with a set of "backward-looking" jaws that allow you to measure the inside diameter of a pipe or other hollow object with a minimum ID (inside diameter) of 3mm to perhaps 4mm.

Using the Electronic Digital Caliper is extremely easy and intuitive.

Slide the jaws open by gently grasping the long "shaft" with one hand and sliding the display unit to the right with the other.

Place the jaws around the object that you're measuring and close the jaws until they no longer move. Read the measurement directly off the units LCD.

You may press the blue, "mm/inch" button located directly above the LCD to change from metric to Imperial and vice versa if desired; if you see the measurement unit you prefer already being displayed, you need do nothing.

Close the jaws when you're finished, and press the small red "OFF / ON" button near the lower left of the display to neutralise the caliper.

To change the cell ("battery") in the Electronic Digital Caliper, slide the ribbed battery hatch (located to the immediate right of the LCD) toward the right until it comes off, and set it aside.

Remove the dead LR44 button cell from the little battery compartment, and dispose of it.

Insert a new LR44 button cell into the chamber, orienting it so that its button-end (-) negative goes in first.

Slide the battery door back on.

Turn the caliper on, press the jaws fully closed, press the yellow "ZERO" button located below the LCD toward the right, and press the red button to turn the caliper off.

This caliper is meant to be used as a measurement instrument in a dry area, not as a flashlight meant to be carried around all the time, thrashed, trashed, bashed, and abused; so I won't throw it against the wall, stomp on it, viciously chuck it at one of those wall-mounted porcelain uranators to see if it becomes broken (the caliper, not the whizzer!), try to drown it in the {vulgar slang term for a fudge bunny}bowl or the cistern, run over it, swing it against the concrete floor of a patio, bash it open to check it for candiosity, fire it from the cannoñata (I guess I've been watching the TV program "Viva Piñata" too much again

- candiosity is usually checked with a scanner-type device on a platform with a large readout, with a handheld wand that Langston Lickatoad uses, or with a pack-of-cards-sized device that Fergy Fudgehog uses; and the cannoñata is only used to shoot piñatas to piñata parties away from picturesque Piñata Island), send it to the Daystrom Institute for additional analyses, launch it into the upper atmosphere of Gamalon V* so that chairman Sonji gets all pissy about it, or inflict upon it punishments that I might inflict upon a flashlight.

So this section of the caliper's web page will be *SIGNIFICANTLY* more bare than this section of the web page on a page about a flashlight.

Photograph of the display of the caliper.

Photograph showing a measurement being taken in inches.

Photograph showing a measurement being taken in millimeters.

Photograph showing a meaurement being taken of the inside diameter of an object.

TEST NOTES:
Unit was purchased on Ebay on 05-04-20 and was received on 05-09-20.

* From the Star Trek: The Next Generation episode, "Final Mission".

UPDATE: 00-00-00

MANUFACTURER: Unknown
PRODUCT TYPE: Digital caliper
LAMP TYPE: N/A
No. OF LAMPS: N/A
BEAM TYPE: N/A
SWITCH TYPE: Pushbutton on/off
CASE MATERIAL: Plastic & metal
BEZEL: N/A
BATTERY: 1x LR44 button cell
CURRENT CONSUMPTION: Unknown/unable to measure
WATER- AND PEE-RESISTANT: No
SUBMERSIBLE: DER TEUFEL TRÄGT EINE WINDEL PINKELN-GETRÄNKTEN NEIN!
ACCESSORIES: 2x LR44 button cells
SIZE: Unknown/unable to measure
WEIGHT: 56g (1.98 oz.) incl. battery
COUNTRY OF MANUFACTURE: Unknown
WARRANTY: Unknown/not stated

PRODUCT RATING:

Electronic Digital Caliper *

Do you manufacture or sell an LED flashlight, task light, utility light, or module of some kind? Want to see it tested by a real person, under real working conditions? Do you then want to see how your light did? If you have a sample available for this type of real-world, real-time testing, please contact me at bdf1111@yahoo.com.

Please visit this web page for contact information.

Unsolicited flashlights, LEDs, and other products appearing in the mail are welcome, and it will automatically be assumed that you sent it in order to have it tested and evaluated for this site.
Be sure to include contact info or your company website's URL so visitors here will know where to purchase your product.

This page is a frame from a website.
If you arrived on this page through an outside link,you can get the "full meal deal" by clicking here.